Filter
Top Products
61
Console Command Reference
CHAPTER 3
get-stp
get-stp
Displays the current state of spanning tree (either enabled or
disabled). By default, spanning tree is enabled in accordance with
802.1d.
SYS_console> get-stp
Running Spanning Tree engine is enabled
Next session the Spanning Tree engine will be enabled
set-stp
set-stp {enable|disable}
Enables or disables the spanning tree protocol. Enabled is the default.
Enabling or disabling spanning tree doesn’t take effect until the
SNMP agent is reset (
warm-reset, cold-reset, or turning the power
off and then on again).
get-st-bcfg
get-st-bcfg
Displays the spanning tree bridge parameters. If spanning tree is
disabled, parameters aren’t displayed.
SYS_console> get-st-bcfg
802.1D SPANNING TREE BRIDGE INFO
==================================
Designated Root : 8000-0020-1a00-0a5b
Bridge Priority : 32768
Root Cost : 0
Root Port : 0
Max Age : 20
Hello Time : 2
Hold Time : 1
Forward Delay : 15
Bridge Max Age : 20
Bridge Hello Time : 2
Bridge Forward Delay : 15