Filter
Top Products
114
C H A P T E R 6 Redirect TCP Packets
114
4 Select the TCP port from the drop-down list or type in the TCP
port number, and click
OK.
Note Any new TCP port number, not previously shown, is
now added to the drop-down list.
5 Click OK.
Setting switch port mode The ports on the front of the switch can be set to one of three modes:
Normal, Cache or Client. These mode settings determine where the
traffic passing through the port is sent. To set the port mode:
Note These port modes are only valid when Redirect TCP pack-
ets is enabled.
1 Select Web Cache Redirection>Setup.
2 Click Switch Ports.
3 Select the correct switch port and click Properties.
4
Assign the correct port mode. For ports assigned as Cache ports,
a polling URL and the IP address of the cache server must be
assigned.
5 Click OK.
500.book Page 114 Thursday, September 2, 1999 1:50 PM