Filter
Top Products
ADE-9040 User’s Manual
23 / 55
3.1.2 Installing Intel µFC-LGA 775 CPU Fan, and Heat Sink
• The Intel µFC-LGA 775 CPU heat sink and fan assembly comes in a push-pin design
and requires no tool to install.
• Place the fan with heat sink right above the CPU and make sure four pins matching
the holes of the board. (8, 9)
• Press all push-pins down and rotate them to lock. (Please check the rear side of the
board.)
• Place the CPU fan connector.
3.1.3 Removing CPU
• Disconnect the CPU fan connector.
• Remove the CPU fan and heat sink first.
• Unlock the Intel µFC-LGA 775 Pentium 4 processor.
• Carefully lift up the existing CPU to remove it from the socket.
• Follow the steps of installing a CPU to change to another one.
Warning： For a safety landing, avoid leaving prongs on hard surface.
Instructions：Smear thermal grease on the top of the CPU. Lower the CPU fan onto the
CPU/CPU socket and secure it using the attachments or screws provided
on the fan. Finally, attach the fan power cable to the CPUFAN adapter. For
more details on this, go to http://www.intel.com
8
9
Push-
p
in
Board’s hole CPU fan connector