Filter
Top Products
Windows 3.x/MS-DOS Installation 4-7
Now continue with the DEC PATHWORKS installation as follows:
1 In Windows 3.x run the Intel Installation Program from Intel Disk
1. Installation Disk, as described at the beginning of this chapter.
2 Choose DEC PATHWORKS from the Select Network Operating
System screen.
3 Follow the prompts to complete the Intel segment of the installa-
tion.
4 Check the README file on your PATHWORKS SETUP disk for
requirements such as lastdrive, setver, etc. You will need 500 K of
free conventional memory and about 1 MB of extended memory to
run PATHWORKS SETUP. Be sure you have a lastdrive statement
in your CONFIG.SYS file (lastdrive=g will work in most cases).
5 Use a text editor to modify the file A:\NDIS\PI.TPL on the
PATHWORKS SETUP disk, as follows (A:\NDIS is a hidden
directory. You can access it by typing CD A:\NDIS):
Change the line
;NI_IRQ = [IRQ VALUE FROM STEP 5 OF THE FIRST PROCEDURE ABOVE]
to read
NI_IRQ = [IRQ VALUE FROM STEP 5 OF THE FIRST PROCEDURE ABOVE]
The NI_IRQ value must be the same as the interrupt value you will
use for the Intel adapter.
6 Run the SETUP program from the PATHWORKS SETUP disk for
LAN Manager.
7a For Pathworks 5.0, choose Configure PC.
7b For Pathworks 6.0, select Yes for the Has the Pathworks software
been installed to a LAN Manager file Service.
8 In the Select Drive Window, choose Network.
9 Select DECnet as transport.
10 When prompted to choose a network adapter, choose Other.
11 When prompted for driver information, in the Other Adapter
window use the following:
a. for PATHWORKS 5.0:
NDIS DRIVER PATH: A:\