Filter
Top Products
4-30 PRO/100 LAN+Modem PC Card User’s Guide
3 Follow the prompts to complete the Intel segment of the installa-
tion.
4 Install PathWay Access for DOS Kernel and Drivers programs
according to the instructions in the PathWay Access for DOS
manual. Before rebooting the PC, continue with the following steps.
5 Use a text editor to modify the CONFIG.SYS file. After the
statement that reads
DEVICE=C:\PATHWAY\PWTCP.SYS
add the lines
DEVICE=\PATHWAY\[PROTMAN FILE] /I:C:\PATHWAY
DEVICE=\PATHWAY\M16BNDIS.EXE
where [PROTMAN FILE] is equal to the PROTMAN2.EXE or
PROTMAN.EXE file that is located in your PATHWAY directory.
(Refer to the Wollongong PathWay Access for DOS manual for
information regarding the differences between these two files.)
6 Copy the file M16BNDIS.EXE from C:\INTEL\M16B directory
to the PATHWAY directory on your hard disk or boot disk.
7 Continue with the custom instructions in the PathWay Access for
DOS manual.
8 Reboot the PC.
Wollongong PathWay ODI Installation
1 Run the Intel Installation Program from the Installation Disk.
2 Choose Wollongong PathWay Access from the Select Network
Operating System screen.
3 Follow the prompts to complete the Intel segment of the installa-
tion.
4 Install PathWay Access for DOS Kernel and Drivers programs
according to the instructions in the PathWay Access for DOS
manual. Before rebooting the PC, perform the following steps.
5 Run the MS-DOS batch file DCOMPVLM.BAT from the Network
Drivers Disk, as follows:
DCOMPVLM PATHWAY
DCOMPVLM.BAT will decompress and copy all required files