Filter
Top Products
Windows 3.x/MS-DOS Installation 4-47
Error Messages for Windows 3.x and
MS-DOS drivers
Except as noted, these messages are specific to the PRO/100 PC Card.
For an explanation of other messages that may appear on the screen, see
your computer and network operating system documentation.
A PCMCIA card was not detected
If the SOCKET keyword was stated, then no PC Card was detected in the
slot specified. If the SOCKET keyword was not used, then no PC Card
was detected in any slot.
An invalid I/O address was specified
The PRO/100 PC Card requires 32 consecutive I/O locations. This
message indicates that the I/O address specified does not start on a 32-
byte boundary. Examples of valid I/O addresses, in hexadecimal notation,
are 300, 320, 240. Examples of invalid I/O addresses are 301, 325, 247.
M16BODI only supports the BUS ID PC Card, not the selected
BUS ID. Either delete the BUS ID keyword from the NET.CFG file
or change its value to 3.
This message applies only to the ODI driver. Do not use the keyword
BUS ID in the ODI NET.CFG file. If you do use it, you must set the
value to 3.
Network Controller running in 8-bit mode
The Network Interface Controller (NIC) has been forced to run in 8-bit
mode with the keyword WORDSIZE set at 8 (default is 16-bit mode).
This option is used when the PC Card hardware does not support 16-bit
mode.
Network Controller running in I/O mode
The Network Interface Controller (NIC) has been forced to run in I/O-
only mode with the keyword MODE set at IO (default is MEM). This
option is used when the PC Card hardware does not support perfor-
mance-enhancing memory-mapped I/O mode.