Filter
Top Products
Windows 3.x/MS-DOS Installation 4-37
do not need IMENABLE.COM because the network drivers also initialize
the modem.)
Reboot the computer and run IMENABLE.COM from the DOS prompt
before launching Windows or a communications program.
IMENABLE.COM Keywords
KEYWORD DEFAULT VALID VALUES
COMX AUTO (X = 1, 2, 3, OR 4)
COMIRQ NOT USED (3 TO 15)
COMBASE NOT USED (0X248 TO 0X3F8)
IOWAITSTATES= AUTO (1, 2, OR 3)
MEMORY= 0XD2000 (0XC0000 TO 0XE0000)
MEMWAITSTATES= AUTO (1, 2, OR 3)
SLOT= AUTO (HARDWARE DEPENDENT)
OFF NOT USED (DISABLES IMENABLE)
Modem Driver Example
A typical sequence for loading the modem driver IMENABLE.COM with
default configuration settings is as follows:
IMENABLE.COM COMX
where COMx is a COM port value such as COM3 or COM4. If other
nondefault configuration settings are used, these must also be stated on
the IMENABLE.COM command line. For example,
IMENABLE COM4 COMBASE=0X320 COMIRQ=10
Windows 3.x Network Driver Parameters
The following paragraphs present configuration guidelines for each of the
driver types: NDIS, ODI, and packet. These guidelines are followed by a
comprehensive keyword reference section and a list of error messages.
All of the drivers described here automatically detect the speed of the
network to which the adapter is attached (10Mbps or 100Mbps), unless
otherwise noted. Speed can also be specified with the LINESPEED
keyword.