Filter
Top Products
4-14 PRO/100 LAN+Modem PC Card User’s Guide
14 Copy the file ODIPKT from disk 5 of the FTP PC/TCP installation
disks to the directory into which PC/TCP was installed.
15 Reboot the PC.
FTP Software PC/TCP Packet Driver Installation with
OnNet 1.1
1 Run the Installation Program from Intel Disk 1, Installation Disk.
2 Choose FTP PC/TCP from the Select Network Operating System
screen.
3 Follow the prompts to complete the Intel segment of the installa-
tion.
4 Exit to DOS, switch to the C:\INTEL\M16B directory and run
M16BPD.COM.
5 Install PC/TCP software according to the directions given in the
PC/TCP documentation.
6 Copy the file M16BPD.COM from the C:\INTEL\M16B directory
to the PC/TCP directory specified in the PC/TCP install procedure.
7 Edit the AUTOEXEC.BAT file and add the following lines:
C:\PCTCP\M16BPD.COM
C:\PCTCP\ETHDRV.EXE
8 (This step is not required for PC/TCP versions 2.10 and later.)
Using a text editor, add the following lines to your CONFIG.SYS
file:
DEVICE=[
PATH
]IPCUST.SYS
DEVICE=[
PATH
]IFCUST.SYS
where [path] is the drive and directory specified at the PC/TCP
installation.
9 Reboot the PC.
10 Change to the directory where your PC/TCP files are stored and
run M16BPD.COM by typing:
M16BPD
11 Run the ETHDRV.EXE kernel program supplied with PC/TCP.
This loads the PC/TCP kernel into memory. The packet driver must
always load before the kernel.