Filter
Top Products
Installing and Replacing Mobile Board Components
43
Installing the Mobile Board
This section describes how to install the Mobile Board in the notebook chassis. The
installation consists of the following procedures:
1. Connecting the Mobile Board to Expansion Board A
2. Attaching the C-plate to the D-tray
Before you perform these procedures, observe the precautions in "Before You Begin"
on page 35.
Connecting the Mobile Board to Expansion Board A
To connect the Mobile Board to Expansion Board A, see Figure 14 and follow these
steps:
1. Connect the Expansion Board A cable (Figure 14, B) to the Expansion Board A
connector (Figure 14, A) on the bottom of the Mobile Board.
2. Turn
the board over and place it into the D-tray as show in the figure. Take note
of the location of the Expansion Board A board-to-board connector (Figure 14, D)
on the bottom of the Mobile Board.
3. Connect
the Mobile Board board-to-board connector (Figure 14, D) to the board-to-
board connector (Figure 14, C) on the top of Expansion Bo
ard A and snap them
together. The Mobile Board mounting holes will align with the matching standoffs
in the D-tray.
4. Secure the Mobile Board to Expansion Board A with the screw (Figure 14, E)
supplied with
Expansion Board A.