Filter
Top Products
Installing and Replacing Mobile Board Components
47
Attaching the Touch Pad and the Fingerprint
Reader (optional) Cables
This section describes how to connect the touch pad and fingerprint reader cables to
the Mobile Board after it has been installed in the chassis. To connect the cables, see
Figure 17 and follow these steps:
1. Observe the
precautions in "Before You Begin" on page 35.
2. Turn the chassis over so that it is orien
ted (top side up) as shown in Figure 17.
3. If
the touch pad installed in the C-tray includes an optional fingerprint reader,
there will be two cables to connect. The touch pad cable attaches to the touch pad
connector (Figure 1, H) and the fingerprint reader cable attaches
to ID Expansion
Connector B (Figure 1, G). The installation process is the same for both cables.
4. To connect
either of the cables:
a. Open the connector locking mechanism (Figure 17, A) by sliding it out as shown
i
n the figure.
b. Insert the cable into the connector (Figure 17, B).
c. P
ush the locking mechanism (Figure 17, A) back in to lock the cable in place.