Filter
Top Products
Hardware Installations and Upgrades
18 Intel
®®
Server System R1000GZ/GL Service Guide
Removing and Installing the System Cover
Removing the System Cover
The server system must be operated with the system cover in place to ensure proper cooling. You will
need to remove the top cover to add or replace components inside of the server. Before removing the
top cover, power down the server and unplug all peripheral devices and the power cable(s).
Note: A non-skid surface or a stop behind the server system may be needed to prevent the server
system from slding on your work surface.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the power cord.
4. Remove the four screws (see letter "A").
5. Slide cover back and lift upward (see letter "B").
Figure 22. Removing the System Cover
Installing the System Cover
1. Place system cover onto the chassis and slide forward to engage recessed edge at front of
cover (see letter “A”).
2. Tighten the four screws (see letter “B”).
Figure 23. Installing the System Cover