Intel R1304GL4DS9 Server User Manual


 
Hardware Installations and Upgrades
34 Intel
®®
Server System R1000GZ/GL Service Guide
Installing and Removing the Intel
®
Remote Management
Module 4
Installing the Intel
®
RMM4 Lite
Locate the RMM4 Lite connector next to Riser Slot 1, carefully pickup the Intel
®
RMM4 Lite
module, match the alignment pin of the module and the connector on server board, then press to
install.
Figure 56. Installing the Intel
®
RMM4 Lite
Install the Intel
®
RMM4 NIC
1. Push out and remove the metal cover on the chassis where the NIC RJ-45 receptacle will align
(see letter “A”).
2. Position the module over the server board, fit the front of the module into the back panel slot,
then attach the module to the server board connector (see letter “B”).
3. Secure the module with the two screws as shown (see letter “C”).
Figure 57. Installing the Intel
®®
RMM4 NIC
Removing the Intel
®®
RMM4 Lite
Pull up the RMM4 Lite module to remove it from the mother board.