Filter
Top Products
Upgrading Your Computer 21
Replacing the System Cover
After adding optional components and making adjustments,
replace the system cover. Follow these steps:
1.
Make sure you have not left any tools or loose parts inside
the system. Make sure everything is properly installed
and tightened.
2.
Lower the cover straight down over the chassis.
3.
Slide the cover forward until the rear of the cover aligns
with the rear of the chassis. Make sure the cover screws fit
into the notches on the sides of the system cover.
4.
Tighten the screws on the rear of the system.
Installing Add-in Boards
The computer has expansion slots for installing add-in boards,
such as modems, sound cards, or video adapters. The system
has five 16-bit ISA slots and two 32-bit PCI slots.
The expansion slots are on a circuit board, called the riser card,
which is perpendicular to the system board.
Removing the Bottom Panel
Before adding or removing cards from your system, you will
need to remove the bottom panel. To remove the bottom panel
of the system:
1.
Gently tilt the system onto its right side (as you face the
front of the system).
3694manl.bk : 3694manl.fm Page 21 Tuesday, December 24, 1996 9:15 AM