Filter
Top Products
Upgrading Your Computer 29
clip fits into indentations at the top and bottom of
the rail and snaps into place (Figure 15).
Figure 15. Installing Guide Rails
b.
Position each guide rail so that the end with the
tab faces the front of the drive, and the grounding
clip is next to the drive. Align the mounting holes
on the drive with the holes on the guide rail.
c.
Attach the guide rails to each side of the drive by
installing four mounting screws (Figure 15).
5.
Slide the drive into the bay, until the tabs on the guide
rails snap into the slots on the drive bay (Figure 16). To
remove a drive, press the tabs on the guide rails until the
drive slides freely.
3694manl.bk : 3694manl.fm Page 29 Tuesday, December 24, 1996 9:15 AM