Filter
Top Products
22 Advantage! 9000 Series User’s Manual
Figure 10. Removing the Bottom Panel
2.
Remove the screw that holds the bottom panel in place
(Figure 10).
3.
Slide the bottom panel toward the rear of the system until
the two tabs at the bottom front of the system clear their
slots.
4.
Remove the bottom panel from the chassis.
Board Installation
Follow this procedure to install an add-in board.
1.
Run any software that is required before installing the
board:
•
If you are installing an ISA add-in board that does not
comply with the Plug and Play specification, you will
need to configure it manually, using the Windows 95
Add New Hardware Wizard. See your Windows 95
documentation for more information.
•
If you are installing an ISA or PCI add-in board that
complies with the Plug and Play specification, the
board is ready to install.
3694manl.bk : 3694manl.fm Page 22 Tuesday, December 24, 1996 9:15 AM