Filter
Top Products
36 Advantage! 9000 Series User’s Manual
2.
To access the SIMM slots, you must first remove the rear
drive bay:
a.
Remove the rear drive bay panel (see “Removing
the Rear Drive Bay Panel” on page 32).
b.
Remove any drives that may be mounted in the
rear drive bay panel by pressing in on the tabs on
the drive rails and pulling the drives out of the
drive bay.
c.
Slide the drive cage out of the tabs that secure it to
the chassis, and remove from the chassis.
3.
Locate the SIMM slots on the system board. Refer to the
illustration in the back of this manual.
4.
If necessary, remove any add-in boards that block easy
access to the SIMM slots.
5.
If you need to remove a SIMM, carefully pull the retaining
clips from the edges of the SIMM (Figure 19). At the same
time, push the SIMM slightly forward from the back.
Remove the SIMM carefully to avoid damage.
3694manl.bk : 3694manl.fm Page 36 Tuesday, December 24, 1996 9:15 AM