Filter
Top Products
32
• When performing simultaneous or individual operation,
use the remote control.
MENU/EXIT
MODE
ID +/–
2 / 3
5 /
5
DISPLAY ASPECT POWER
RGB
COMPO.
VIDEO B
VOLUME
MULTIPLE
MODE ID SET
MONITOR ADJUSTMENT
VIDEO A
MUTING
MENU/EXIT
RM-C575 REMOTE CONTROL UNIT
ID
Operating the Monitors Simultaneously
• Check that no ID number is shown on the screens. If any ID
numbers are shown, press MODE to erase them.
• The following procedure should be performed slowly and
securely.
Example: When adjusting “CONTRAST”:
1
Press MENU/EXIT to display the Main
Menu.
The Main Menus appear on all the connected Monitors’
screens.
2
Press 5/∞ to move the cursor (3) to
“PICTURE ADJ.”
3
Press 3 to display the Picture
Adjustment Menu.
The Picture Adjustment Menus appear on all the
connected Monitors’ screens.
4
Press 5/∞ to move the cursor (3) to
“CONTRAST.”
5
Press 2/3 to make an adjustment.
At this time, if the Monitors have different
“CONTRAST” settings, the adjustment is made, based
on the different settings.
6
Press MENU/EXIT twice to exit from the
menu operations.
Operating the Monitors Individually
The following procedure should be performed slowly and
securely.
1
Press MODE to display the ID numbers
on all the connected Monitors’ screens.
2
Press ID +/– to select the Monitor you
want to operate.
Example: To select “[02]”:
Press ID + twice.
Slave 2’s ID number “[02]” is highlighted.
* The selected ID number will be also shown on the
Master Monitor (in this example, “MASTER\[02]”).
3
Perform any desired operations, such as
adjusting menu items.
Notes:
• If “[00]” is displayed on all the Monitor screens or if some of
the Monitor screens have no indication in step 1, press
MODE to turn off the indications on all screens, and then
press MODE again.
• If the ID number of the Monitor selected in step 2 is not
highlighted or if the ID numbers of more than one Monitor
are highlighted, press MODE to clear the ID numbers, and
then start the procedure again from the beginning.
CONTRAST
BRIGHT
CHROMA
PHASE
SHARPNESS
sub menu
reset
ADJUST:
PICTURE ADJ.
SELECT:
EXIT:
MENU
VIDEO A
: –01
:
: –02
:
:
00
00
00
CONTRAST
BRIGHT
CHROMA
PHASE
SHARPNESS
sub menu
reset
ADJUST:
PICTURE ADJ.
SELECT:
EXIT:
MENU
VIDEO A
: +01
:
: –02
:
:
00
00
00
CONTRAST
BRIGHT
CHROMA
PHASE
SHARPNESS
sub menu
reset
ADJUST:
PICTURE ADJ.
SELECT:
EXIT:
MENU
VIDEO A
:
:
: –02
:
:
00
00
00
00
CONTRAST
BRIGHT
CHROMA
PHASE
SHARPNESS
sub menu
reset
ADJUST:
PICTURE ADJ.
SELECT:
EXIT:
MENU
VIDEO A
: +02
:
: –02
:
:
00
00
00
When pressing 3 once
Slave 2
Master
Slave 1
Slave XX
MASTER
[00] [00] [00]
Serial Connections and Operations (Continued)
Slave 2
Master
Slave 1
Slave XX
MASTER\[02]
[01] [02] [XX]
31-40.GD-V4210PZW[EN]/f 00.9.29, 5:56 PM32