Filter
Top Products
A-61510 January 2005 2-3
3. Determine if any changes to the Image Processing
parameters need to be made for the current application.
NOTE: This check needs to occur for up to four separate images
from the six available options depending on your
application: Front Color, Front Bi-tonal, Front Grayscale,
Rear Color, Rear Bi-tonal, Rear Grayscale.
Image Processing parameter changes remain in effect until
one of the following conditions occur:
• The scanner is powered down using the power switch.
• A SCSI bus device Reset command is executed.
• New imaging parameters are sent from the host.
4. It is recommended that you calibrate the scanner. For
procedures on how to do this, see the Kodak i800 Series
Scanners, User’s Guide.
5. Prepare documents according to the instructions found in the
Kodak i800 Series Scanners, User’s Guide.
Enable scanning
The host must issue a Scan command to enable scanning before
documents can be transported through the scanner. If scanning has
not been enabled, the feeder and transport system will not turn on.
Initiate polling
Initiate host system polling of the scanner to ensure scanned
document images are transferred from the image buffer to the host
system. Polling should continue until scanning is disabled.
For more information see the sections entitled, “Controlling
image transfer order” and “Image header information” later in this
chapter.
Feed documents
Feed documents according to the instructions found in the Kodak
i800 Series Scanners, User's Guide.