Kyocera FS-1300D Printer User Manual


 
Glossary-1
Glossary
Additional memory
An additional memory (optional) is used for increasing the memory
capacity of this machine. For DIMM that can be used in this machine,
contact your service technician.
AppleTalk
AppleTalk offers file sharing and printer sharing and it also enables you to
utilize application software that is on another computer on the same
AppleTalk network.
Default Gateway
This indicates the device, such as a computer or router, that serves as the
entrance/exit (gateway) for accessing computers outside of the network
that you are on. When no specific gateway is designated for a destination
IP address, data is sent to the host that is designated as the Default
Gateway.
DHCP (Dynamic Host Configuration Protocol)
This is a protocol that automatically resolves the IP address, Subnet
Mask and Gateway address on a TCP/IP network. Use of DHCP
minimizes the load of network administration, especially on network
environments with a large number of client computers where it is not
specifically necessary to assign a separate IP address to each client,
including printers.
dpi (dots per inch)
This indicates the number of dots printed per inch (25.4 mm) as a unit for
expressing resolution.
EcoPrint
This is a printing mode that reduces toner consumption. Pages printed in
the EcoPrint mode are lighter than pages printed in the normal mode.
Emulation
This refers to emulation of other manufacturers’ printers. The printer
emulates operation of the following printers: PCL6 and KPDL.
Form Feed Timeout
While data is being sent to a printer, some pauses may occur. At this time,
the printer waits for the next data without making a page break. Form feed
timeout is a function to wait only a preset amount of time before it
executes an automatic page break. After the waiting period begins, once
the designated amount of time is exceeded, the printer will automatically
process the currently received data and print it out. If the machine has
received no print data for the last page, the printer ends processing of that
job without outputting paper.