Filter
Top Products
5: Configuration Using Web Manager
Disconnect Mode Settings Description
Check EOT (Ctrl-D)
Select Yes to drop the connection when Ctrl-D or Hex 04 is
detected. Both Telnet Com Port Cntrl and Check EOT
(Ctrl+ D) must be enabled for Disconnect with EOT to function
properly. Ctrl+D is only detected going from the serial port to the
network. The default setting is No.
Inactivity Timeout
Use this parameter to set an inactivity timeout. The unit drops the
TCP connection to port 10001/10002* if there is no activity on the
serial line before the set time expires. Enter time in the format
mm:ss, where m is the number of minutes and s is the number of
seconds. To disable the inactivity timeout, enter 00:00.
Note*: The default port number for Port 1 is 10001 and 10002 for
Port 2. However, port numbers may be set to a different value.
3. When you are finished, click the OK button.
4. On the main menu, click Apply Settings.
Connection Settings - UDP
To configure a channel’s UDP settings:
1. On the main menu, click Connection. The Connection Settings window for the selecte
d
c
hannel displays.
2. In the available fields, enter or modify the following information:
Figure 5-8. UDP Connection Settings
Micro125 User Guide 32