Lantronix 900-588 Network Card User Manual


 
6: Configuration via Telnet or Serial Port (Setup Mode)
Note: The easiest way to enter Setup Mode is to hold down the x key at the terminal (or
emulation) while resetting the unit. You must do this within three seconds of resetting the
Micro125.
At this point, the screen display is the same as when you use a Telnet connection. To
continue, go to step 4, above under the section, Telnet Connection
.
Exiting Setup Mode
To exit setup mode, utilize one of the following two options:
To save all changes and reboot the device, select option 9 Save and exit from the
C
hange Setup menu. All values are stored in nonvolatile memory.
To exit the configuration mode without saving any changes or rebooting, select option
8
E
xit without save from the Change Setup menu.
Micro125 User Guide 37