Lantronix 900-588 Network Card User Manual


 
11: Monitor Mode
Table 11-1. Monitor Mode Commands
Command Command Name Function
VS x.x.x.x
Version
Queries software header record (16 bytes) of unit with
IP address x.x.x.x.
GC x.x.x.x
Get Configuration
Gets configuration of unit with IP address x.x.x.x as
hex records (120 bytes).
SC x.x.x.x
Send Configuration
Sets configuration of unit with IP address x.x.x.x from
hex records.
PI x.x.x.x
Ping
Pings unit with IP address x.x.x.x to check device
status.
AT
ARP Table
Shows the unit’s ARP table entries.
TT
TCP Connection Table
Shows all incoming and outgoing TCP connections.
NC
Network Connection Shows the unit’s IP address, gateway, subnet mask,
and DNS server.
RS
Reset
Resets the unit’s power.
QU
Quit
Exits diagnostics mode.
G0, G1, ....,Ge, Gf
Get configuration from
memory page
Gets a memory page of configuration information
from the device.
S0, S1,...,Se, Sf
Set configuration to
memory page
Sets a memory page of configuration information on
the device.
GM
Get MAC address
Shows the unit's 6-byte MAC address.
SS
Set Security record Sets the Security record without the encryption key
and length parameters. The entire record must still be
written, but the encryption-specific bytes do not need
to be provided (they can be null since they are not
overwritten).
SA
Scan
Initiates a wireless scan if the wireless interface is
enabled. Reports any stations found, including
BSSID, SSID, and RSSI. If SA is followed by a string,
the string is used to filter SSIDs before reporting. If
the BSS does not broadcast its SSID, only the BSSID
and RSSI are returned.
NS
Network Status
Reports the network interfaces’ statuses. Includes
potentially negotiated parameters like speed/duplex
for Ethernet or BSSID, encryption, authentication for
wireless interfaces.
co
Set IP address,
hostbits, gateway ,
and DNS server IP
Example:
co 192.168.0.10 8 192.168.0.1 10001 192.168.1.10
with
192.168.0.10 = IP address of the Micro125
8 = number of hostbits
192.168.0.1 = gateway IP address
10001 = port number of the Micro125
192.168.1.10 = IP address of the DNS Server
The Micro125 stores the setup and performs a reset.
It sends an X before the reset if the command was
OK.
Micro125 User Guide 67