Filter
Top Products
5: Configuration Using Web Manager
xDirect User Guide 28
Host List Configuration
The xDirect scrolls through the host list until it connects to a device listed in the host list table. After
a successful connection, the unit stops trying to connect to any others. If this connection fails, the
unit continues to scroll through the table until the next successful connection.
The host list supports a minimum of 1 and a maximum of 12 entries. Each entry contains an IP
address and a port number.
Note: The host list is disabled for Manual and Modem Mode. The unit does not accept a
data connection from a remote device when the hostlist option is enabled.
To configure the host list:
1. On the main menu, click Hostlist.
Figure 5-5 Hostlist Settings
2. Enter or modify the following fields:
Retry Settings
Host Information
3. When you are finished, click the OK button.
4. On the main menu, click Apply Settings.
Retry Counter Enter the value for the number of times the xDirect should attempt to retry
connecting to the host list. The default setting is 3.
Retry Timeout Enter the duration (in milliseconds) the xDirect should abandon attempting a
connection to the host list. The default setting is 250.
Host Address Enter or modify the host’s IP address.
Port Enter the target port number.