Filter
Top Products
3: Installation of PremierWave XN
PremierWave XN User Guide 23
Using the CLI
To enter the command level: enable -> config -> if 2 -> link
To Cancel WPS
Using the CLI
To enter the command level: enable -> config -> if 2 -> link
To Show WPS Status
Using the CLI
To enter the command level: enable -> config -> if 2 -> link
Installing the PremierWave XN
Be sure to place or mount the device securely on a flat horizontal or vertical surface. The device
comes with mounting brackets for mounting the device vertically, for example on a wall. If using
AC power, avoid outlets controlled by a wall switch.
Observe the following guidelines when connecting the serial devices:
The PremierWave XN serial ports support RS-232/422/485.
The null modem cable is the best cable to connect the serial device to another DTE device.
Th
e straight-though (modem) cable is the best cable to connect the serial port to a DC
E
devic
e.
Connect your RJ-45 Ethernet cable to the RJ-45 port of the unit.
The device supports a power range of 9 to 30 VDC. You can power up the device with barrel-
power connector and/or the 3 pin terminal connector for backup power supply.
Note: As soon as you plug the device into power, the device powers up automatically,
the self-test begins, and LEDs would indicate the device's status
Perform the following steps to install your device:
1. Connect devices to the serial po
rts.
2
. Connect a RJ-45 Ethernet cable between the unit and your Ethernet network.
3. Connect the Antennas to the SMA connector on the side. Do note that the safe distance due to
RF exposure from antenna is 23cm
.
Note: Anten
nas must be installed prior to powering on the unit. Do not remove or
connect the antennas while the unit power is on.
4. Plug the PremierWave XN into the power outlet by using the included power supply.