Filter
Top Products
a. Note the top view and the bottom view of the battery card assembly. Then, insert the battery pack
harness connector into the 5-pin J3 battery pack harness connector on the backside of the battery
card assembly.
Figure32. Bottom view of the battery card assembly
1 J3 battery pack harness connector
2 J1 connector
3 J2 board-to-board connector
Figure33. Top view of the battery card assembly
1 Battery pack harness
b. With the front side up, place the RAID controller on a at, clean, static-free surface.
Chapter 5. Installing, removing, or replacing hardware 43