Filter
Top Products
4. Look through the front bottom opening in the printer and find the
finger grips at the bottom of the forms device.
5. Grasp the finger grips with BOTH hands and pull firmly toward
you and then upward until both ends LOCK into place.
Finger Grips
6. To be sure that you have installed the forms device correctly,
look at the following figure and compare it to your printer. Check
both the left and right sides. Are the clips around the platen rod
as shown? If so, you installed the forms device correctly. If not,
repeat Steps 3 on page 1-89 through 5.
Platen Rod
Platen Rod
Clip
Clip
1-90 User’s Guide