Filter
Top Products
Installing and Using the Continuous Forms Device
(F1)
The following sections describe how to install and use the
Continuous Forms Device (F1).
Note: Make sure that the proper forms device is configured. See
“Preparing for Forms Device Installation” on page 1-10 for the exact
steps.
Installing the Continuous Forms Device (F1)
To install the F1 forms device, follow these steps:
1. Hold the forms device so that the device number F1 is in the
upper left corner facing you. Note the bottom metal bar and the
clips; they will be important later.
2. Remove the orange shipping clip, if installed.
Important
The F1 forms device for the 4230 Printer has a circle around
the F1 emblem. Use only these forms devices in the 4230
Printer.
Top of Forms Device
Bottom Metal Bar
Clips
F1
Tensioner Plates
Chapter 1. Setting Up the 4230 Printer 1-21