Filter
Top Products
Lexmark X215
29
• If zone coating of the adhesive is not possible, a 3 mm (0.125 in.) strip should be removed on
the leading and driver edge, and a non-oozing adhesive should be used.
• Remove a 3 mm (0.125 in.) strip from the leading edge to prevent labels from peeling inside
the printer.
• Portrait orientation is preferred, especially when printing bar codes.
• Do not use labels that have exposed adhesive.
• Do not use labels that are separating from the backing sheet or are wrinkled, bubbled, or
otherwise damaged.
• Do not load a sheet of labels through the machine more than once.
• Load labels into the manual bypass feeder with the recommended print side face up and the
top edge going in first.
When printing on card stock:
• Set the Paper Type to Card Stock from the printer driver.
• Do not use preprinted card stock manufactured with chemicals that may contaminate the
printer. Preprinting introduces semi-liquid and volatile components into the printer.
• Do not use card stock that is creased. It may cause paper jams.
• We recommend the use of grain short card stock.
• Load card stock into the manual bypass feeder with the recommended print side face up and
the top edge going in first.