Lexmark Laser Printers Printer User Manual


 
Lexmark X422
31
For paper and transparency specifications, refer to the Lexmark X422 Publications CD.
When printing on labels:
Set the Paper Type to Labels from the printer driver, the Local Printer Setup Utility, or
MarkVision.
Do not load labels together with paper or transparencies in the same paper source.
Do not use label sheets with a slick backing material.
Do not print within 1 mm (0.040 in.) of the die cut.
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a
paper jam. Partial sheets will also contaminate your printer and your cartridge with adhesive,
and could void your printer and cartridge warranties.
Use labels that can withstand temperatures of 205°C (401°F) without sealing, excessive
curling, wrinkling, or releasing hazardous emissions.
Use labels that can withstand pressure of 25 pounds per square inch (psi).
Do not print within 1 mm (0.040 in.) of the edge of the label, of the perforations, or between
die-cuts of the label.
Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone
coating of the adhesive at least 1 mm (0.040 in.) away from edges. Adhesive material will
contaminate your printer and could void your warranty.
Portrait orientation is preferred, especially when printing bar codes.
Do not use labels that have exposed adhesive.
For the tray, load labels with the recommended print side face down.
Media Specifications
Labels Width: 76.2 to 216 mm (3.0 to 8.5 in.)
Length: 127 to 355.6 mm (5 to 14 in.)
Weight:
Up to 199 g/m
2
(53 lb)
Thickness: Up to 0.25 mm (0.01 in.)
Smoothness: 100 to 400* Sheffield
* 150 - 250 Sheffield is optimal. Using media higher than 300 Sheffield could result in printing degradation.
Card Stock Weight:
Up to 163 g/m
2
Index Bristol (90 lb)
Up to 163 g/m
2
Tag (100 lb)
Note: Always use the rear exit when printing on card stock. To minimize curl, use the rear exit when
printing on labels.