Filter
Top Products
Aligning the optional finisher
36
Installing and removing options
c Align and insert the screws into the screw holes on the high capacity feeder.
To remove the factory installed spacer:
a Remove the spacer from the top of the caster.
b Insert the four screws through the caster.
c Align and insert the screws into the screw holes on the high capacity feeder.
5 Tighten the four screws to secure the caster.
6 Repeat steps 3 through 5 to add or remove spacers on the remaining three casters.
Note: If installing or removing height adjustment spacers does not bring the high capacity feeder to the right
height, you may need to raise or lower to height of the feet on your printer cabinet or printer base.
Aligning the optional finisher
Note: Failure to properly align the finisher may cause paper jams.