Filter
Top Products
Printing a network setup page
55
Printing
Printing a network setup page
If the printer is attached to a network, print a network setup page on the printer to verify the network connection. This page
also provides important information that helps in configuring for network printing.
1 Make sure the printer is on.
2 Press on the operator panel.
3 Press until Reports appears, and then press .
4 Press until Network Setup Page appears, and then press .
Note: If an optional MarkNet N8000 series internal print server is installed, Print Net1 Setup appears on
the display.
5 Check the first section on the network setup page, and confirm that Status is “Connected.”
If Status is “Not Connected” is on the page, the LAN drop may not be active, or the network cable may be
malfunctioning. Consult a system support person for a solution, and print another network setup page to verify that
the printer is connected to the network.
Printing a font sample list
To print samples of the fonts currently available for your printer:
1 Make sure the printer is on and the Ready message appears.
2 Press on the operator panel.
3 Press until Reports appears, and then press .
4 Press until Print Fonts appears, and then press .
5 Press until the appears next to PCL Emul Fonts, PostScript Fonts, or PPDS Fonts, and then press
.
Printing a directory list
A directory listing shows the resources stored in flash memory or on the hard disk. To print a listing:
1 Make sure the printer is on and the Ready message appears.
2 Press on the operator panel.
3 Press until Reports appears.
4 Press .
5 Press until Print Directory appears.
6 Press .
The message Printing Directory List appears on the display.
The printer returns to the Ready state after the directory list prints.