Filter
Top Products
55
Set up the optional finisher
Unpacking the finisher
CAUTION! If you are installing the
finisher sometime after initial printer
setup, turn the printer off and unplug the
power cord before continuing.
1 Remove the cardboard box by
lifting it straight up and setting it to
the side.
2 Remove the foam from the top of
the finisher and by the legs.
3 Lightly press on the tabs located
on the metal locking brackets near
each leg, and move both brackets
toward the middle of the finisher.
Metal locking bracket
Ta b s
jp_setup.book Page 55 Friday, February 16, 2001 7:42 AM