Filter
Top Products
14
Installation
3
Installation
CAUTION
Do not attempt to tighten a screw too tightly. If you do, the thread groove or the grip of the locking nut may become
damaged.
Tighten a screw to x a monitor on the stand base so that it does not separate. This may cause an accident.
4. Once assembled, lift the monitor up carefully and face the front side.
CAUTION
Do not make the monitor stand by holding the camera. It can be broken and damaged.
Disassembling the stand
1. Place the VCS with its front facing downward on a soft cloth.
2. Turn the Stand locking screw counterclockwise to disconnect the stand base from the monitor.
Using the Kensington security system (optional)
The Kensington security system connector is located at the rear of the VCS. Connect the Kensington security system cable
between the VCS and a table.
NOTE
The Kensington security system is optional. You can obtain additional accessories from your local dealer.