Filter
Top Products
10
Chapter 4: Connecting the Wireless-G Ethernet Bridge for Setup
Wireless-G Ethernet Bridge with 5-Port Switch
Chapter 4: Connecting the Wireless-G Ethernet Bridge
for Setup
1. Attach the Bridge’s antenna.
2. Plug the included Ethernet network cable into one of the five LAN ports on the back panel of the Bridge,
shown in Figure 4-1.
3. Plug the other end of the Ethernet network cable into the RJ-45 port of the hub, switch, or PC you wish to use
to configure the Bridge.
Figure 4-1: Connect to the Network