Filter
Top Products
When You Cannot Print
55
4
If the printing does not start, consult your service representative.
Printing does not start. If the machine is operat-
ing in an extended wire-
less LAN, the receiver's
MAC address may be
preventing communica-
tion with the access point.
Check access point settings when in the
infrastructure mode. Depending on the
access point, client access may be limit-
ed by MAC address. Also, check there
are no problems in transmission be-
tween access point and wired clients,
and between access point and wireless
clients.
Printing does not start. The extended wireless
LAN has not started.
Confirm the orange LED is lit, and the
green LED is lit or blinks during trans-
mission.
Printing does not start. The login user name, log-
in password, or driver
encryption key is invalid.
Check the login user name, login pass-
word, or driver encryption key.
Printing does not start. Advanced encryption has
been set using the Ex-
tended Security function.
Check the settings of the Extended Se-
curity function with the administrator.
Data-in lamp does not
blink or light up.
If the data-in lamp is unlit
or not flashing even after
performing [Print], the
machine has not received
the data.
• When the machine is connected to a
computer via a cable, check the
computer print port settings are cor-
rect. See “Confirming the Connec-
tion Method”, Printer Reference.
• When it is networked with a com-
puter, Contact the administrator.
The status indicator of
the printer is lit.
The cause is displayed on
the display of the control
panel.
Check the error message on the display
panel and take required action. See p.51
“When a Message Appears”.
“
Updating the des-
tination list...
Please wait. Speci-
fied destination(s)
or sender's name
has been cleared.
”
appears.
The destination list is be-
ing updated from the
network using SmartDe-
viceMonitor for Admin.
Wait until the message disappears. Do
not switch off the power while this
message is displayed. Depending on
the number of destinations to be updat-
ed, there may be some delay before you
can resume operation. Operations are
not possible while this message is dis-
played.
[List / Test Print] is dis-
abled.
A mechanical error might
have occurred.
Contact your service representative.
See “List/Test Print”, General Settings
Guide.
Printing does not start
when using the extended
wireless LAN in Ad-hoc
mode.
The correct Communica-
tion mode is not set.
Turn the main power off and back on.
See “Turning On/Off the Power”,
About This Machine.
Or, change the settings for [System Set-
tings], [Interface Settings], and [Network].
See “Network Settings”, General Set-
tings Guide.
Problem Cause Solution