Filter
Top Products
14
Hardware Installation
2.3 DIP Switch Settings for Processors
(For Factory Use Only)
You cannot overclock an Intel Celeron
TM
PPGA processor because
its frequency ratio has been fixed by the manufacturer. Therefore
SW1 on the system board is used for factory testing only. The table
on the next page, which shows the supported processors and their
corresponding DIP switch settings, are for reference.
In the example above:
Switch 1: Off
Switch 2: On
Switch 3: Off
Switch 4: On
1. Pull the tabs which are at the ends of the socket to the side.
2. Position the DIMM above the socket with the notches in the
module aligned with the keys on the socket.
3. Seat the module vertically into the socket. Make sure it is
completely seated. The tabs will hold the DIMM in place.