Filter
Top Products
Hardware Installation
17
2.6 Jumper Settings for Wake-On-Keyboard/
Wake-On-Mouse (ATX power supply only)
Jumper JP1
Wake-On-Keyboard/Wake-On-Mouse
The system board supports
the Wake-On-Keyboard/Wake-
On-Mouse function. This
function allows you to use the
keyboard or mouse to power-
on the system. By default, JP1 is
disabled. To use this function,
set JP1 to 2-3 On. Keyboard/
Mouse Power On in the
Integrated Peripherals setup of
the Award BIOS must be set
accordingly. Refer to chapter 3
for details.
Warning:
1. If JP1 was previously enabled with a password set in the
KB Power On Password field, and now you wish to disable
the Wake-On-Keyboard (password) function, make sure to
set the Keyboard/Mouse Power On field to Disabled prior
to setting JP1 to disabled. You will not be able to boot up
the system if you fail to do so.
2. The power button will not function once a keyboard
password has been set in the KB Power On Password
field of the Integrated Peripherals setup. You must type the
correct password to power-on the system.
3. The 5VSB power source of your power supply must
support
≥
720mA (minimum).
2-3 On: Enable
1-2 On: Disable
(default)
321
3
21