Filter
Top Products
44
!
Award BIOS Setup Utility
Soft-Off by PWR-BTTN
This category allows you to select the method of powering off your
system.
Hold 4 Sec. Regardless of whether the Power Management field is
enabled or disabled, if the power button is pushed
and released in less than 4 sec, the system enters the
Suspend mode. The purpose of this function is to
prevent the system from powering off in case you
accidentally hit or pushed the power button. Push
and release again in less than 4 sec to restore.
Pushing the power button for more than 4 seconds
will power off the system.
Instant-Off Pressing and then releasing the power button at
once will immediately power off your system.
PWR Lost Resume State
Keep Off When power returns after an AC power failure, the
systems power is off. You must press the Power
button to power-on the system.
Turn On When power returns after an AC power failure, the
system will automatically power-on.
Last State When power returns after an AC power failure, the
system will return to the state where you left off
before power failure occurs. If the systems power is
off when AC power failure occurs, it will remain off
when power returns. If the systems power is on
when AC power failure occurs, the system will power-
on when power returns.
Resume On Ring
With an external modem installed, the Modem Ring-on function will
allow your system to power-on to respond to incoming calls. By
default, the Resume on Ring field is Disabled. To use this function,
please follow the steps below.
1. Make sure the computer system is powered off.
2. Connect the external modem to the COM 1 or COM 2 serial
port.
3. Switch on the power of the external modem.