Filter
Top Products
Hardware Installation
27
2.7.12 Wake-On-LAN Connector (ATX power supply only)
The system board supports the Wake-On-LAN function. This function
will allow the network to remotely power-on a Soft Power Down
(Soft-Off) PC. However, if your system is in the Suspend mode, you
can power-on the system only through an IRQ or DMA interrupt.
To use the Wake-On-LAN function, you must enable the Resume on
LAN field in the Power Management Setup of the Award BIOS.
Your LAN card package should include a cable. Connect one end of
the cable to the wakeup header on the card and the other end to
location J14 on the system board. The network will detect Magic
Packet and assert a wakeup signal to power-up the system. Refer to
the add-in cards manual for details. Note: Your LAN card must
support the remote wake up function.
Pin
1
2
3
Function
+5VSB (720mA)
Ground
WOL
Important:
The 5VSB power source of your power supply must support
≥
720mA (minimum).