Mitsubishi Electronics WD390U-EST Projector User Manual


  Open as PDF
of 69
 
EN-15
Important:
• Theautomatickeystoneadjustmentmaynot
be carried out correctly because of the ambient
temperature and the installation conditions of the
projector and the screen. In such cases, correct the
keystone manually.
• Whentheprojectorisprojectingimageswhere
acceleration is present, such as in a vehicle and
aircraft, the automatic keystone adjustment may
not function correctly. In such a case, set Auto
Keystone in the Installation menu to Off and correct
the keystone manually.
• Youcancorrecttheverticalkeystones.However,
their adjustment ranges are limited in such
correction.
• Whenthekeystoneadjustmentiscarriedout,the
adjustment value is indicated. Note that this value
doesn’t mean a projection angle.
• Theallowablerangeoftheadjustmentvaluein
the keystone adjustment varies depending on
the installation condition, input signal and aspect
settings in MENU.
• Whenthekeystoneadjustmenttakeseffect,the
MAGNIFY mode and the Overscan function cannot
be used.
• Whenthekeystoneadjustmenttakeseffect,the
resolution decreases. In addition, stripes may
appear or straight lines may bend in images with
complicated patterns. They are not due to product
malfunctions.
• Noisemayappearonthescreenduringthe
keystone adjustment because of the type of the
video signal being projected and the setting values
of the keystone adjustment. In such cases, set the
keystone adjustment values in the range where the
image is displayed without noise.
• Whenthekeystoneadjustmentiscarriedout,the
image may not be displayed correctly because of
the type of input signal.
When entire projected image
isn’t displayed within the screen
(E-Zoom/Shift)
To adjust the projected image size and position, use
E-Zoom/Shift in the Installation menu.
(See page 21 for menu setting.)
1. Display the Installation menu.
2. Press the or button to select E-Zoom/Shift.
E-Zoom/Shift
OK
3. Press the ENTER button.
• TheE-ZOOM/SHIFTmenuappearsatthecenter
of the screen.
E-ZOOM
SHIFT
VOL
4. Press the VOLUME or button to adjust the
projected image size.
• EverytimetheVOLUME button is pressed,
the projected image becomes larger.
• EverytimetheVOLUME button is pressed,
the projected image becomes smaller.
• Projectedimageisamaximumasfactory
default.
E-ZOOM
SHIFT
VOL
Original image size
(= maximum image size)
Reduced image
5. Press the , , or button to move the
projected image position.
• Everytimethe button is pressed, the
projected image moves up.
• Everytimethe button is pressed, the
projected image moves down.
• Everytimethe button is pressed, the
projected image moves to the left.
• Everytimethe button is pressed, the
projected image moves to the right.
Adjustable in any of
four directions
E-ZOOM
SHIFT
VOL
Important:
• Whenyoureducetheprojectedimageusingthe
E-Zoom/Shift function, the resolution decreases. In
addition, stripes may appear or straight lines may
bend in images with complicated patterns.
Preparation (continued)
 previous next