Mitsubishi Electronics WD390U-EST Projector User Manual


 
EN-66
Specifications
Type DLP™ projector
Model WD390U-EST
Rated power supply 100 - 240 V AC, 50/60 Hz
Power consumption 3.4 A
During standby: 0.5 W (when Standby Mode is Low)
Display Technology 0.65-inch single chip Digital Micromirror Device (DMD)
Pixels: 1280 x 800 = 1024000 pixels
Colors 16770000 colors
Projection lens F 2.7, f = 5.4 mm
Light source lamp 230 W
Picture size 70-180 inch (aspect ratio 16:10)
PC compatibility Resolution: 640 x 480 (Expand) - 1280 x 800 (Real) - 1600 x 1200 (Compress)
Sync on Green available
Video compatibility NTSC/NTSC 4.43/PAL (including PAL-M, N)/SECAM/PAL-60
Component Video (DVD/HDTV) (480i, 576i, 480p, 576p, 1080i, 720p, 1080p)
Speaker 10 W mono x 1
S-video input Luminance signal: 1.0 Vp-p 75 Ω (negative sync.)
Chroma signal: 0.286 Vp-p 75 Ω (burst signal)
Video input 1.0 Vp-p 75 Ω (negative sync.)
Audio input 350 mVrms, 10 kΩ or more
Analog RGB input RGB: 0.7 Vp-p 75 Ω (negative sync.)
YP
B
P
R
/YC
B
C
R
:
Y: 1.0 Vp-p (negative sync.)
P
B
P
R
/C
B
C
R
: 0.7 Vp-p
HD/CS: TTL level (positive or negative)
VD: TTL level (positive or negative)
HDMI input
HDMI 19-pin
HDMI interface (TMDS single link) (only PCM audio is supported)
Control connector SERIAL terminal (RS-232C), LAN terminal (RJ-45)
Outside dimensions 325 x 113 x 258 mm (width x height x depth) (not including protrusion)
Weight Approx. 4.1 kg
Temperature, humidity
(performance guaranteed)
+41°F(+5°C)-+95°F(+35°C),30-90%
• Thespecicationsandoutsideappearanceoftheprojectoraresubjecttochangewithoutpriornotice.