Filter
Top Products
Technical Reference • • Appendix B
37
1 MOXA board not found.
Hardware causes and solutions:
a The I/O address user has selected for MOXA board conflicts with
that of other interface boards such as SCSI, LAN, or Sound boards.
If so, adjust the I/O address to forestall the conflict.
b The MOXA board is not properly plugged in the system. If that is
the case, then re-install the board and make sure that it fits well in a
16-bit slot this time. Sometimes the slot for plugging MOXA
board is bad. In this case, please try other slots until a good one is
found.
c The MOXA board is not installed or missing (absent). Please
install it.
d The MOXA board is defective. Please check the MOXA board(s)
ONE AT A TIME in the system and find out the defective one. It
is also recommended to check it under DOS with F3 Diagnostics
function of utility "SETUP" to verify the hardware conditions.
Software Cause and Solution:
a The I/O address setting on board is not the same as the setting in
configuration software.
2 "Can not find any C360 Async Concentrator" error message.
This message shows that none of the configured Async Concentrator(s)
is found. The message will not show if AT LEAST ONE of the
configured Async Concentrator(s) is found.