Filter
Top Products
FTP
FTP is the other means available for VPort 2140 Video Server to send out alarm messages and
snapshots. To send the system log files described in the above paragraph via FTP, the SMTP
server should be erased.
1. Local FTP server port can also be changed to a setting different from the default setting of
21. Administrators should have enough network knowledge to change the default port.
2. Administrators must enter correct Primary FTP Server, Primary FTP user name, and
Primary FTP password.
3. Primary FTP remote folder is the sub-folder in the remote FTP server.
4. If the remote FTP server’s port is changed to a setting different from 21, make sure to set the
real port to Primary FTP server port.
5. If the local network is protected by a firewall to prevent it from initiating an FTP connection
from the remote FTP server, you may be able to connect to the FTP server, but be unable to
place a file on the server due to data channel connection failure. Check Primary FTP passive
mode for a passive transfer solution.
6. Another set of Secondary server settings is also provided for a backup connection.
In either e-mail or FTP, the primary server information should be entered first. If the primary
server is not set, the related FTP or email will be cancelled. Note that it may take time to
connect to the secondary server after the first one fails, and it may affect some applications
when conditions occur too often.
Save the modification
After all necessary modifications are made, click on Save to store the modifications. A warning
message will appear for confirmation. After clicking on OK, the VPort will automatically restart.
If the Reset network at next boot option is checked, perform the software installation again.
Otherwise, the VPort will boot up automatically using the new configuration settings.
If you make any changes to the settings in this web page, the system will restart to validate
those changes. Make sure that every field is correctly typed before clicking on Save. If the
VPort fails to respond due to incorrect settings, perform the restore procedures and run the
software installation.
Administrators should take note that the basic network settings, including IP address, subnet
mask, default router, and DNS servers, should be set to factory defaults before switching the
network interface from “Ethernet” to “modem” or from “modem” to “Ethernet.”
VPort 2140 User’s Manual
4-8