Filter
Top Products
MultiModemISI Hybrid Series, ISIHI-2S 133
Appendix
Appendix E: Configuration Profiles
Quick Setup Factory Profiles
For quick setup, the Terminal Adapter includes four Quick Setup Factory Profiles, each of
which is configured for a specific type of port operation. You can load a Quick Setup
Factory Profile into active memory by using the command &Fn, where n is the number of
the profile you want to load. If you want, you can then customize the profile and store it,
using the &W command so that it loads automatically when the TA is turned on or reset.
These profiles are stored in permanent memory and are not user-configurable as such.
&F0 Profile 0—Modem-like asynchronous operation (default)
&F1 Profile 1—V.120 asynchronous operation
&F2 Profile 2—X.75 asynchronous operation
&F3 Profile 3—ML-PPP asynchronous operation
Quick Setup Example
The following procedure assumes you want to load, modify, and store Quick Setup
Factory Profile 2 as your default configuration. (The parameters for Profile 2 are listed in
Table A-3.)
1. Select the profile closest to the requirements of your application, in this case, Quick
Setup Factory Profile 2.
2. In terminal mode, type AT&F2 and press ENTER. Quick Setup Profile 2 loads into
the TA’s active memory.
3. Enter any additional AT commands that you need to customize the selected profile to
your application (see Chapter 5,
Terminal Adapter AT Commands, S-Registers,
Result Codes
).
4. Type AT&W0 and press ENTER to save your customized port configuration.
5. Your customized profile now loads automatically whenever the TA is turned on or
reset.