Filter
Top Products
MultliModemISI Hybrid Series, ISIHI-2S 93
Chapter 5—TERMINAL ADAPTER AT Commands, S-Registers, Result Codes
Terminal Adapter
Topic Command Description Page
Command Execution AT Attention code 94
Return Command execution
+++AT<cr> In-band escape code
<BREAK>AT<cr> Out-of-band escape code
Switch Configuration %A97 Dialing method 94
!C0 Switch type
!C6 Data SPID
*!C6 Voice SPID
!D3 SAPI-0 data TEI
*!D3 SAPI-0 voice TEI
!L List DN, SPID, TEI, Data protocol and switch type
>Dn Embedded Protocol Analyzer
!N1 Data directory number
*!N1 Voice directory number
!Z=n Rate adaptation protocol
Serial Port Configuration En Command mode echo 95
L List telephone numbers
L5 List current operating parameters
L6 List S-register values
L8 Display low level ISDN status
Qn Status displays
Sr=n Set S-register
Sr? Read S-register
Vn Terse/verbose result codes
Xn Connect messages
Z Restore parameters to current power-up profile
&Cn DCD (Data Carrier Detect) control
&Dn DTR (Data Terminal Ready) control
&En Flow control
#Xn Send Single Multiple Xoff Characters
&Fn Load quick setup factory profile
&Rn CTS (Clear To Send) control
&Sn DSR (Data Set Ready) control
&V View port configuration
&Wn Store active profile
&Zn= Store telephone number
DSn Dial a Stored telephone number
$Dn Persistent DTR dialing
%En Escape sequence options
@P3= Parity
@P4= Data bits
@P6= Stop bits
Data Call Commands A Answer 103
D Dial
H Hang up
In Display product information
O Return online
@Config Start ConfigMenu