Filter
Top Products
54 MultiModemISI Hybrid Series, ISIHI-2S
Chapter 3—Software/Driver Installation
SCO Open Server 5 Driver Installation
The installation utility provided by SCO is called custom. This section provides a brief
guide for opening the utility and installing the driver. The instructions below should be
used only on SCO Open Server 5 systems. When you have completed the steps below,
go to Multi-Tech Installation Script, which immediately follows this section.
1. If installing the driver from your default floppy drive, type custom and press ENTER to
open the custom utility. If using a nondefault drive, you must inform your system of
the disk drive from where you are doing the installation and the size and capacity of
the diskette(s).
2. Select Software and press ENTER.
3. The main menu displays a list of options. Press ENTER to select the highlighted item
(default): Install.
4. Select From comsco and press ENTER.
5. Make sure the driver diskette is in the floppy diskette drive and then press ENTER to
select the highlighted item (default): Floppy Disk Drive 0. The following message
appears: Examining media. Please wait …
6. The system recognizes you are installing the Multi-Tech Serial Card Driver and
prompts you to select the type of installation.
7. Select Full Installation and press ENTER to continue. These messages appear:
Extracting Files...
Executing Multi-Tech Serial Card Driver Init Script...
8. When installation finishes, this prompt appears:
Do you wish to continue ( y / n / q ):?
Type Y, press ENTER, and proceed with the next section,
Multi-Tech Installation
Script
.