Muratec MFX-3090 All in One Printer User Manual


 
103
P
r
i
nte
r
Sett
i
ng
s
i
n
W
in
d
o
ws
Advanced
tab
1. You can specify which times of day your printer will be available.
2. Indicates current priority, from 1 (lowest) to 99 (highest). Highest priority
documents will print first.
3. Specifies that documents should be spooled (stored in a special print file) before
being printed. The document is then printed in the background, allowing your
application program to become available more quickly. Options follow:
This specifies that printing should not start until the last page has been spooled. If
your application program needs a lot of time for further computation in the middle
of printing, causing the print job to pause for more than a short period, the printer
could prematurely assume that the document has finished. Selecting this option
would prevent that situation, but printing will be completed a little later, as the
start is delayed.
This is the opposite choice to the one above. Printing starts as soon as possible
after the document begins spooling.
4. This specifies that the document should not be spooled, but printed directly. Your
application will not normally be ready for further use until the print job is
complete. This requires less disk space on your computer, since there is no spool
file.
5. Directs the spooler to check the document setup and match it to the printer setup
before sending the document to print. If a mismatch is detected, the document is