Filter
Top Products
CHAPTER 5 FEATURE DESCRIPTION
Page 124 NEAX 2000 IPS General Description
NDA-24345, Issue 3
IP Enabled Dterm
This feature provides a Dterm Series E/Series i terminal, if equipped with an IP adapter unit with a
capability to provide a converged infrastructure at the desktop, with a 10Base-T/100Base-TX
Ethernet connection to corporate Local Area Networks (LAN). The IP Enabled Dterm can
communicate with other IP Enabled Dterm and CCIS network (IP based) on a peer-to-peer
connection basis. And, the IP Enabled Dterm also communicates with legacy stations and trunks
(TDM based) via IPPAD (IP Packet Assembler/Disassembler). The IP Enabled Dterm provides users
with all features currently available in Dterm Series E/Series i terminals.
Last Number Redial
This feature allows users to redial the last station-to-station or outside number they dialed using a
feature access key or a feature access code. This is useful when the called station is busy or does not
answer.
Least Cost Routing - 3/6 Digit
This service feature allows the NEAX2000 IPS to be programmed to route outgoing calls over the
most economical facility (WATS, FX, DDD). Based on the individual area code and office code
dialed (6-digit analysis), the system examines the programmed tables and uses the trunk in the order
specified.
Line Lockout
This feature automatically releases a station from the common equipment if the station remains off-
hook for longer than a programmed interval before dialing. Howler tone may be programmed to be
sent to the station in Line Lockout.
Line Pre-selection
This feature provides the station user with two ways to select an idle, held, recalling, or ringing line
before going off-hook.
Maid Status
This feature allows the Hotel/Motel (H/M) Front Desk Instrument, Property Management System
(PMS) terminal, or guest room station (using special access code) to register the condition of each
guest room.
Maintenance Administration Terminal (MAT)
The Maintenance Administration Terminal (MAT) is a personal computer that provides an interface
to the PBX via the system’s CPU card. The MAT PC must have the MATWorX program properly
installed to communicate with the PBX. MATWorX is required for system software registration and
activation. MATWorX is a Graphical User Interface (GUI) program that provides an efficient
method to manipulate the PBX database. This program contains extensive help files, Usage Wizards
and Tool Tips, with hyperlinks imbedded in the text. The hyperlinks provide quick access to the
appropriate Add-In modules. Add-In modules provide a user friendly intuitive method to customize
the PBX database.