Filter
Top Products
CHAPTER 4 EQUIPMENT DESCRIPTION
NEAX 2000 IPS General Description Page 93
NDA-24345, Issue 3
Installation Hardware
Equipment Name Function
HANGER ASSEM
(UL)
Wall Hanger Assembly
One HANGER ASSEM is required per PIM for Wall Mounting
installation.
19 INCH RACK
BRACKET (A)
19-inch Rack Mounting Bracket Type A
One bracket is required for one PIM configuration.
One bracket is required for the top PIM of multiple module
configuration.
19 INCH RACK
BRACKET (B)
19-inch Rack Mounting Bracket Type B
One bracket is required for the bottom module of multiple module
configuration.
MOUNTING
BRACKET
Safety Mounting Bracket
Used as an overhead hanger for Floor Standing Installation.
Wire, chain or eyebolts are to be locally provided, to secure the
bracket. To be installed on the top PIM in four or more modules
of stack. It provides 1.1G shockproof construction.
I/F BRACKET
ASSEM
Inter Frame Bracket Assembly
Used to joint the frames in two-frame configuration, for Floor
Standing Installation.
BASE TRAY ASSEM Base Tray Assembly
One BASE TRAY is required per one frame for Floor Standing
Installation of Stationary Equipment.
System Power
Abbrev Name Code Remarks
PZ-PW121
AC/DC PWR Main Power Supply Card:
Input: AC120 V/240 V (50 Hz/60 Hz)
Output: –27 V (4.4 A), +5 V (7.2 A), CR (38 mA),
+90 V (80 mA)
One card is pre-installed per PIM.
PZ-PW122
DC/DC PWR Power Supply Card for Cell Station (Zone Transceiver):
Input: –24 V DC
Output: –48 V DC (1.7 A)
One card per PIM.
A maximum of 16 CS (ZTs) backed up by one card.
PN-PW00
EXTPWR Power Supply Card for DESKCON:
• Provides –48 V DC power.
• A maximum of four cards per frame (4PIMs).
A maximum of three cards per PIM.
• Occupies two physical slots width per card.