NEC V300X Projector User Manual


  Open as PDF
of 99
 
12
2. Installation and Connections
COMPUTER IN
PHONE
PHONE
AUDIO IN
Making Connections
Connecting Your PC or Macintosh Computer
NOTE: When using with a notebook PC, be sure to connect the projector and notebook PC while the projector is in standby mode
and before turning on the power to the notebook PC.
In most cases the output signal from the notebook PC is not turned on unless connected to the projector before being powered up.
* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power manage-
ment software.
Enablingthecomputer’sexternaldisplay
Displaying an image on the notebook PC’s screen does not necessarily mean it outputs a signal to the projector.
When using a PC compatible laptop, a combination of function keys will enable/disable the external display.
Usually,thecombinationofthe‘Fn”keyalongwithoneofthe12functionkeysgetstheexternaldisplaytocomeon
oroff.Forexample,NEClaptopsuseFn+F3,whileDelllaptopsuseFn+F8keycombinationstotogglethrough
external display selections.
VGA signal cable
(supplied)
To mini D-Sub 15-pin con-
nector on the projector. It is
recommended that you use a
commercially available distri-
bution amplifier if connecting
a signal cable longer than
the cable supplied.
IBM VGA or Compatibles
(Notebook type) or Ma-
cintosh (Notebook type)
NOTE:ForolderMacintosh,
use a commercially available
pin adapter (not supplied)
toconnecttoyourMac's
video port.
Stereo mini-plug audio cable
(not supplied)
AUDIO IN
AUDIO IN COMPUTER 1IN
COMPUTER 2 IN
V300X/V260X
VGA signal cable
(supplied)
Stereo mini-plug audio
cable (not supplied)
NOTE:
• Beforeconnectinganaudiocabletotheheadphonejackofacomputer,adjustthecomputer’svolumeleveltolow.Afterconnecting
the projector to the computer, adjust the volume of both projector and computer to suitable level as desired to avoid damage to
your ear.
• Ifanaudiooutputjackofyourcomputerisaminijacktype,connecttheaudiocabletoit.
•
AnimagemaynotbedisplayedcorrectlywhenaVideoorS-Videosourceisplayedbackviaacommerciallyavailablescanconverter.
This is because the projector will process a video signal as a computer signal at the default setting. In that case, do the following.
- When an image is displayed with the lower and upper black portion of the screen or a dark image is not displayed correctly:
ProjectanimagetollthescreenandthenpresstheAUTOADJ.buttonontheremotecontrolortheprojectorcabinet.
- V230X/V260/V230:TheCOMPUTERINconnectorsupportsPlug&Play(DDC2B).
V300X/V260X:BoththeCOMPUTER1INandCOMPUTER2INconnectorssupportPlug&Play(DDC2B).
V230X/V260/V230
 previous next